Perform the bulk setting change for indoor unit (Bulk Edit Split System)

Bulk setting changes for Split system indoor units can be performed on the Split System Dashboard screen.

(a) Tap the link menu to open the bulk change modal for the Split System indoor unit. In the bulk change modal, select the indoor unit you want to change, and then select the tab of the function you want to change.

Select Units

(a) Select Units tab
When the indoor unit is selected, is displayed.

(b) Select Units

Selects the indoor unit to be the target of the bulk setting.

(c) Select All

Selects all indoor units.

(d) Deselect All

Deselects all indoor units.

General

(a) General tab
When any of (b) to (h) is changed, is displayed.

(b) Power

Sets On/Off for Power.

(c) Filter Reset

Sets On/Off for Filter Reset. (When On, filter sign is reset.)

(d) Economy Mode

Sets On/Off for Economy Mode.

(e) Antifreeze Mode

Sets On/Off for Antifreeze Mode.

(f) WLA Restart

Sets On/Off for WLA Restart.

(g) WLA LED

Sets On/Off for WLA LED.

(h) Air Flow

Sets the airflow.

Temperature Setpoints

(a) Temperature Setpoints tab
When (b) is changed to Enable, is displayed.

(b) Enable Edit

Sets whether Setpoint and Mode are changed or not.

(c) Setpoint and Mode

Sets Setpoint and Mode.

NOTE: When the following message is displayed, select Indoor Unit from the Select Units tab first.

Occupancy Sensor Settings

(a) Occupancy Sensor Settings tab
When (b) is changed to Enable, is displayed.

(b) Enable Edit

Sets whether Occupancy Sensor Setting are changed or not.

(c) Occupancy Sensor Settings

Auto Economy, Auto On/Off (future support), Auto Off and each operation time can be set.

NOTE: "Auto On/Off" and "Auto Off" cannot be used at the same time. Either of them is disabled.

The relationship among "Auto Economy" absence detection time, "Auto On/Off", and "Auto Off" absence detection time setting is shown below.

"Auto Economy" absence detection time < "Auto On/Off" absence detection time
"Auto Economy" absence detection time < "Auto Off" absence detection time

NOTE: Items that do not have the function of Occupancy Sensor Settings cannot be set.

RC Prohibition (Lockout)

(a)RC Prohibition (Lockout) tab
When (b) is changed to Enable, is displayed.

(b)Enable Edit

Sets whether RC Prohibition is changed or not.

(c) RC Prohibition (Lockout)

Sets whether each of All Operations, Timer, Setpoint, Operation Mode, Start/Stop Operation, Start Operation, or Filter Reset Operation is prohibited or not.

NOTE: "Start/Stop operation" and "Start operation" cannot be used at the same time. Either of them is disabled.

Apply

(a) APPLY button

Performs the bulk sending of only the settings configured to indoor unit.

NOTE: The set values may not be reflected correctly depending on the current operating conditions of the indoor units. So, it is recommended to check each indoor unit is set correctly 2 minutes after the bulk sending.